DeX Spool Holder A8

This is a support for filament coils that allows you to quickly remove and place a new filament in the printer to print. I'm not a big fan of having rods or tubes and I wanted something low profile. They are hooked in the frame of the Anet A8, indicating that they are adapted to the Brackets Leo_N http://www.thingiverse.com/thing:1872162 and that makes it have a little less space (21.3 mm).

**Soon I will adapt it to the normal version so that everyone who wants it can use it.**

I used 608 bearings that I bought at a local skate shop. I printed the nuts and the screws with a slightly higher filling, around 30% to 40%, it is not necessary to tighten them very tightly since it does not tighten the bearing (With a horizontal expansion of -0.15 it enters well and does not loosen).

The main supports I printed with 20%, but I'm sure that even lower will work, but not much lower than that.

----------------------------------------------------------

Este es un soporte para las bob