DF64 clump crusher(s)

MAKE SURE TO SCALE TO 2540% IN CURA BEFORE PRINTING

Some alternative "clump crushers" I've been trying in the DF64/Turin/Solo in place of the dual silicone flaps. I'm currently running a single piece (the 30 degree triangular normal) and have been having relatively good success with it. I do RDT each time (squirt with a little spray bottle) and that makes the static fairly manageable. Very very fluffy grinds, especially when paired with some SSP high uniformity burrs!

I actually found the best results by running two in parallel (the left two in the second picture, with the window pane more proximal to the chute). But I had some difficulty seating the faceplate with two on, so I'm at the one (as above) for now.

I don't run any spacers. A single piece is fairly close to the thickness of two silicone flaps. I have not had any contact issues with the sweeper arms, but use and test at your own discretion. You can rotate the bottom burr by hand to manually verify that there is no