Thingiverse
DHT-22 plate holder
by vaxxi
2
Downloads
0
Likes
0
Makes
Flat surface holder for the DHT-22 gas sensor.
My sensor's PCB was ~13x28.5 mm; depending on the manufacturer, there can be small variations - try heating the holder a little and pull the legs into place for a good fit, if needed.
My sensor's PCB was ~13x28.5 mm; depending on the manufacturer, there can be small variations - try heating the holder a little and pull the legs into place for a good fit, if needed.
vaxxi also publishes on
63 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
