Thingiverse
Dial indicator back plate
door nemesis200
41
Downloads
29
Likes
5
Makes
since my dial indicator had a flange on the back I designed this replacment to make it easier to use with the solidoodle holders.
since it is pretty thin and the holes are small I would sugest printing at .1 for the print and the first layer. At .1 it took about 30minutes to print on SD3. Not sure if this will fit most indicators
since it is pretty thin and the holes are small I would sugest printing at .1 for the print and the first layer. At .1 it took about 30minutes to print on SD3. Not sure if this will fit most indicators
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!