Thingiverse
Dial Indicator Mount for MGN12H Linear Block
by GiulianoM
1
Downloads
1
Likes
0
Makes
Dial Indicator mount for a MGN12H linear rail block, with arm lengths of 50mm, 75mm, and 100mm center to center.
The mounting hole for the dial indicator is 9.75mm, should be a press fit for a 9.5mm dial indicator shaft.
Use the holder to measure up and down flatness of the rail, and insert tinfoil shims until the readings are consistent across the length of the track.
Hardware:
1 x M5 20mm screw and M5 nut for the arm mounting.
4 x M3 10mm screws for mounting the adapter block to the MGN12H carriage.
1 x M3 screw, 10-15mm long for securing the dial indicator.
The mounting hole for the dial indicator is 9.75mm, should be a press fit for a 9.5mm dial indicator shaft.
Use the holder to measure up and down flatness of the rail, and insert tinfoil shims until the readings are consistent across the length of the track.
Hardware:
1 x M5 20mm screw and M5 nut for the arm mounting.
4 x M3 10mm screws for mounting the adapter block to the MGN12H carriage.
1 x M3 screw, 10-15mm long for securing the dial indicator.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!