Thingiverse
Dial Indicator Swivel Joint Clamp
von NWP_Engineering
75
Downloads
51
Likes
1
Makes
Here's a dial indicator clamp I designed when my metal one broke. The one I needed was meant for an 8mm bar. But I also designed a 10mm one in case someone needs it.
Uses an M6 hex head bolt (10mm wrench size). More than likely, the plastic knob on your dial indicator has M6x1.00 threads.
Print at 100% infill. PLA will work, but I chose ABS since it may be exposed to some hot Summer temps in the shop.
Uses an M6 hex head bolt (10mm wrench size). More than likely, the plastic knob on your dial indicator has M6x1.00 threads.
Print at 100% infill. PLA will work, but I chose ABS since it may be exposed to some hot Summer temps in the shop.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
