Thingiverse

Diamond Dice Tower

von nitrocubane

34 Downloads

23 Likes

0 Makes

I wanted a dice tower with different paths the dice could take, but have them all end up in the same place. The tower is designed to print all in one piece without any supports and prints great at 0.28 mm layer height on my Ender 5. I have also included a taller version, but 298 mm might be excessive. 15% cubic infill makes this model plenty strong.

DD dice dice tower dice tray dungeons and dragons tabletop tabletop gaming DD dice dice tower dice tray dungeons and dragons tabletop tabletop gaming

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Warum?

Print-in-place-Design · 0.28mm Schichten

Print-in-place

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat

STL

Material

PLA

Schichthöhe

0.28 mm

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Diamond Dice Tower

Ähnliche Modelle

Zur Sammlung hinzufügen