Thingiverse
Diana Mod 75 sealing ring replacement
by XeS0r
5
Downloads
3
Likes
0
Makes
Custom Diana Mod 75 sealing ring replacement.
Tested with:
- Diana Mod 75
**If you like my designs and don't mind I would be happy about a beer. (Tip Designer)**
v4:
- No changes since release
**Additional requirements**
* None
**Printing**
- Layer height: 0.1-0.2 mm
- Support: no (not needed!)
- Infill: 100%
- Brim: yes
- Material: TPU (preferred)
**Assembly**
After printing remove the brim material and make sure the little hole is clean/empty.
Tested with:
- Diana Mod 75
**If you like my designs and don't mind I would be happy about a beer. (Tip Designer)**
v4:
- No changes since release
**Additional requirements**
* None
**Printing**
- Layer height: 0.1-0.2 mm
- Support: no (not needed!)
- Infill: 100%
- Brim: yes
- Material: TPU (preferred)
**Assembly**
After printing remove the brim material and make sure the little hole is clean/empty.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!