Diaper Caddy

I got tired of getting out of bed in the middle of the night and walking across the room to the opposite side of my bedroom to get diapers and wipes, just to go back to the other side to change my newborn sons diapers. So I designed this over in TinkerCAD and posted a few photos to a FB 3D printing page and received a ton of requests for the files

Theres a section that holds my TV remote, diapers/burp rags, wipes, and even a bottle. On the side of the wipes section are two prongs that hold binkies too. As long as the bottle diameter is less than about 80mm (I don't remember, feel free to check my math) then it should fit. It fits the two diameter sizes of the Philips Avent bottles, water bottles, soda bottles, etc

I'll make a few other versions of this as well, such as without the TV remote holder, just a blank template, etc and upload as I have free time

I printed without supports and slowed the print speed on the overhangs just a tad, but obviously results may vary. 16hrs total, a