Thingiverse
Diatone #37 Eachine 700TVL support
door snub
13
Downloads
8
Likes
0
Makes
This is a support for the Eachine 700TVL camera in the front of the Diatone #37 frame.
The camera is this (http://www.banggood.com/Eachine-700TVL-13-Cmos-FPV-110-Degree-Camera-w32CH-Transmission-p-965760.html)
There is a little gap in the back and on top of the camera so you can fit a small piece of EVA or other smooth foam to prevent damage in case of shock.
The camera is tilted 10 degrees.
Power trails are clear as last picture can show.
This was printed on ABS 0.3 layer height for time sake, however I foresee no problem with higher resolution. Infill at 30%.
Enjoy.
The camera is this (http://www.banggood.com/Eachine-700TVL-13-Cmos-FPV-110-Degree-Camera-w32CH-Transmission-p-965760.html)
There is a little gap in the back and on top of the camera so you can fit a small piece of EVA or other smooth foam to prevent damage in case of shock.
The camera is tilted 10 degrees.
Power trails are clear as last picture can show.
This was printed on ABS 0.3 layer height for time sake, however I foresee no problem with higher resolution. Infill at 30%.
Enjoy.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!