Thingiverse
Dice Shelf
von ATT_Turan
17
Downloads
8
Likes
0
Makes
This is a modular dice shelf I designed to display my promotional dice from Gen Con, but it will work with any 16mm dice and similarly-sized tins or other storage.
To build your shelves:
- The "upper end" model is one display. To display multiple sets horizontally, place as many "upper section" models as you like to its left. I suggest placing them in your slicer so they get printed as a solid piece if possible, but you can certainly print them separately and glue them together.
- If you want more than one shelf, the topmost shelf will use the upper section/end models, and everything below that uses the lower section/end. These work identically to the upper, but have support braces to allow vertical stacking. You can stack as many layers as you like. There are small blocks and slots to help in lining up the shelves, but they're not large enough to support the structures solidly, so I suggest a bit of glue in there.
To build your shelves:
- The "upper end" model is one display. To display multiple sets horizontally, place as many "upper section" models as you like to its left. I suggest placing them in your slicer so they get printed as a solid piece if possible, but you can certainly print them separately and glue them together.
- If you want more than one shelf, the topmost shelf will use the upper section/end models, and everything below that uses the lower section/end. These work identically to the upper, but have support braces to allow vertical stacking. You can stack as many layers as you like. There are small blocks and slots to help in lining up the shelves, but they're not large enough to support the structures solidly, so I suggest a bit of glue in there.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
