Dicengard w/ Dice Storage

WIP Until all pieces have been printed and tested.

Dicengard Remixed to have a storage tray for your Dice.
(The top piece is unchanged and may be found here: https://www.thingiverse.com/thing:2739056)

I printed Original (no version) with no supports without much issue. Points that may need support are under the windows and along the far back edge where the tray slides in. I fixed this area with some Polycrylic and shear snips.

"wRail + Gate" IS VERY EXPERIMENTAL and is meant to be removed from the back of dicengard, remove the gate, and be placed where the dice tumble out in order to catch them.

V2 and the Removable Gate are untested. If you happen to print these, please post a comment or photo so i may adjust the design if needed.


06/28/18: Printed the "No Rail" setup. Tight fit and tray stays in without issue.
07/01/18: Original design extruded nearly all of the inner down slope leaving it weak with
only 1-2 layers.
07/07/18: Added only