Thingiverse
Diecast Wall Mounts with optional riser
por welderlogic
9
Descargas
7
Likes
0
Makes
10" x 4" wall mounted die cast shelf. There is a full print with a 1/16th in base that took me 5 1/2 hours to print. that is the 10 degree full diecast shelf file.
there there is an optional riser print i used to dial in the c-c but it fits pretty well in the full shelf print. the c-c works with 1999 mattel diecasts at 4 5/8" wheel spacing.
then my die cast wall mount stl file is the v3, features a 14 degree angle, a open bottom, sturdy enough to hold the heavier cars, while saving a ton of plastic and time, total print time on my kobra max was 3 1/2 hours.
no supports needed, i used a brim but you probably dont need that either.
designed on tinkercad
this is one of my first designs, open to comments / criticism. Cheers.
there there is an optional riser print i used to dial in the c-c but it fits pretty well in the full shelf print. the c-c works with 1999 mattel diecasts at 4 5/8" wheel spacing.
then my die cast wall mount stl file is the v3, features a 14 degree angle, a open bottom, sturdy enough to hold the heavier cars, while saving a ton of plastic and time, total print time on my kobra max was 3 1/2 hours.
no supports needed, i used a brim but you probably dont need that either.
designed on tinkercad
this is one of my first designs, open to comments / criticism. Cheers.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!