Thingiverse
Diffuser Hose Hook
door uzosan
1
Downloads
2
Likes
0
Makes
Attach a hose to the hook and have an air diffuser in your aquarium.
One connector is for a hose with an inner diameter of 12mm. The other one can be used for a hose with an inner diameter of 9mm up to 12mm.
If you need other inner diameter, just pick one and scale the print, e.g. 133% to scale 12mm to 16mm (16/12*100)
You may need to add support on the outside to print this.
Be aware that most printers do not print in a waterproof manner. You may need to apply epoxy/synthetic resin paint/varnish to prevent leakage.
One connector is for a hose with an inner diameter of 12mm. The other one can be used for a hose with an inner diameter of 9mm up to 12mm.
If you need other inner diameter, just pick one and scale the print, e.g. 133% to scale 12mm to 16mm (16/12*100)
You may need to add support on the outside to print this.
Be aware that most printers do not print in a waterproof manner. You may need to apply epoxy/synthetic resin paint/varnish to prevent leakage.
uzosan publiceert ook op
20 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
