Thingiverse
DigiPi case - Audio Injector
von jameslee522
3
Downloads
1
Likes
0
Makes
First!
First ever case for the digipi. This is a work in progress and I am open to ideas for changes. This case was made for the audio injector board with room for a PTT circuit.
All holes are for M3 screws and designed to be self tapped by driving the screw in to allow it to cut its own threads.
Connect used is a RC servo style or JST SM 5 Pin connector. Only using 4 pins, just using 5 for alignment.
First ever case for the digipi. This is a work in progress and I am open to ideas for changes. This case was made for the audio injector board with room for a PTT circuit.
All holes are for M3 screws and designed to be self tapped by driving the screw in to allow it to cut its own threads.
Connect used is a RC servo style or JST SM 5 Pin connector. Only using 4 pins, just using 5 for alignment.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!