Thingiverse
Music
Model downloaden
Digitakt/Digitone Stand
6
Downloads
8
Likes
1
Makes
Quick-to-print stand to raise your Digitakt by 4.5cm or 2.5cm. Minimum plastic, but sturdy enough to not be afraid to press encoders.
The stand is attached with two 12mm M4 screws with the corresponding washers.
The stand is attached with two 12mm M4 screws with the corresponding washers.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
