Thingiverse
Digital Camera Battery Door Latch
von LankyKong
0
Downloads
0
Likes
0
Makes
Latch for old digicams with broken battery doors, it should work on any camera that has enough of a shelf for you to superglue the pin to it.
*** You'll need to measure the size latch you need for your camera, I printed these files at 20% for mine but YMMV***
No supports required, print at the smallest layer height you can manage (I did 0.08 in the image but .12 seemed to work fine too.)
- The pin has a base that is superglued to the camera itself.
- The latch goes through the pin and the cap is superglued on the shaft to keep it in place (USE A TOOTHPICK to accurately put down a small amount of glue)
- The spacer is optional, it goes underneath the fingernail part of the latch to hold the battery door flush, it may not be required but my battery door has a negative contact for the battery and I wanted to make sure it was held tight.
*** You'll need to measure the size latch you need for your camera, I printed these files at 20% for mine but YMMV***
No supports required, print at the smallest layer height you can manage (I did 0.08 in the image but .12 seemed to work fine too.)
- The pin has a base that is superglued to the camera itself.
- The latch goes through the pin and the cap is superglued on the shaft to keep it in place (USE A TOOTHPICK to accurately put down a small amount of glue)
- The spacer is optional, it goes underneath the fingernail part of the latch to hold the battery door flush, it may not be required but my battery door has a negative contact for the battery and I wanted to make sure it was held tight.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
