Thingiverse
Fashion
Zum Modell
Dilbert Tie and Glasses
133
Downloads
128
Likes
0
Makes
Everyone's favorite engineer! Dilbert!
The tie is printed in alternating red and black PLA. I used super glue to piece them together (inserts included but optional to increase area for the glue). Used the hook part to clip on to my collar. Once assembled, I set the tie between two rags and poured hot water on them. Once warm, I bent the tie into the trademark Dilbert shape.
The glasses are printed in three sections and held together with superglue.
A white short sleeve button up and some pens and the costumes complete!
The tie is printed in alternating red and black PLA. I used super glue to piece them together (inserts included but optional to increase area for the glue). Used the hook part to clip on to my collar. Once assembled, I set the tie between two rags and poured hot water on them. Once warm, I bent the tie into the trademark Dilbert shape.
The glasses are printed in three sections and held together with superglue.
A white short sleeve button up and some pens and the costumes complete!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
