Dillon 550 Calibre Conversion Kit Box

Box to hold a Dillon 550 Calibre conversion kit.
Note: I haven't printed this exact version. I did print a v1 which works fine but had a few issues worth fixing:
V1 was a couple of mm off square (but looked square) so it made the lid a 50/50 bet whether you'd get it right. v2 is square
V1s pin holes were a bit tight (had to drill them out) - V2's are bigger.
V1s funnel holder was a bit tight and deep so V2 is larger and not inset as far.
V1s "knobs" to stop the shell plate spinning were smaller.
V1 didn't have a central "peg" for the shell holder (it did, but it didn't print properly :)
Added insets on pins so you can get a nail under them.

The Photo shown is v1 with a .32 cal conv kit in it.


If anyone does print this, let me know how it goes. My v1 works fine for me, so I don't need to print v2...