Dillon 650 Case Feed Aligner

A re-design of my previous model.

The main bracket is two pieces to allow simpler printing with fewer supports and to provide adjustment of the pivot arm clearance.

Print the small Bracket Rod Guide solid or with 3 walls. It may snap if you are too forceful adjusting it for depth, so maybe print a couple. It is intended to be a sacrificial piece if the rod is somehow jammed against the shell plate. It is easier to print another small piece than a new bracket. The hole goes all the way through the bracket to allow you to push any broken piece out of the bracket if things break.

One of the pivot arms is a bare rod that works just fine to locate the cases.
The other pivot arm has a square end to allow fitting of a matching nose piece if you want more surface area against the empty case. Depending on your printer, it may require a little bit of sanding on the square end to fit the nose piece, or not.



SET UP for a 650 (I do not have access to a 750 but the press frame looks similar)