Dimensional shrinkage calibration

[ENGLISH]🧩 Shrinkage Calibration Results – ABS MG94 National 3D (Pink)After completing Calibration → Flow → Step 1 and Calibration → Flow → Step 2 in Orca Slicer,I printed this Shrinkage Test with Filament → Material Settings → Shrinkage (XY) set to 100 (Step 1).After printing (Step 2), I measured the model using a digital caliper (Step 3).Then, in the slicer under Filament → Material Settings → Shrinkage (XY),I entered the value measured with the caliper (Step 4).I printed the model again and took a new measurement (Step 5).For me, a measurement of 100.09 mm is perfectly acceptable.🧪 My test results – ABS MG94 National 3D (Pink)Printer: Voron 2.4Nozzle temperature: 220 °CBed temperature: 100 °CLine width settings:Standard: 0.40 mmFirst layer: 0.48 mmOuter wall: 0.40 mmInner wall: 0.40 mmSparse infill: 0.40 mmSolid infill: 0.40 mmWall generator: CLASSIC💡 Reminder:Each spool of ABS may have a slightly different extrusion factor.Repeat this test whenever you change filament brand, col