Dimple Button PLA+ AMS Feeder Guide

I tried them all and nothing would snap on to the AMS buttons of my two new units purchased May 2024 so I downloaded this file and hacked away at it in MS 3D Builder to create one that actually snapped on to my AMS and did not rattle or easily come loose. I added a bullseye dimple that your thumb naturally gets traction on and makes loading a breeze. I printed in PLA+ - Plenty strong and snappy. PETG is even better, just see my updated Bullseye Model for PETG. These print solid for maximum durability and tight fit. You hook the front end on the existing feeder button and snap on the top. If it comes right off, you did not snap it on right. It is a little fiddly but works great once you get it on. 40mm Bambu PTFE tubes add guidance and smooth feeding. I tried Capricorn tubing and the ID was a little too tight and there was a little drag. The PTFE fits very tightly and wont come out. Steady even pressure to install without kinking the PTFE is required. “Use the Force” as they say. :P Def