Thingiverse
Electronics
Model downloaden
DIN Mount for 1/2 Height Breadboard
211
Downloads
144
Likes
0
Makes
35mm DIN rail mount for half-height prototyping breadboard.
The frame can be mounted either horizontally or vertically on two DIN clips. The friction fit is excellent with PLA, but the parts should probably be bonded for permanent use.
The pegs on the clips print fine without supports. Initial fit may be a bit tight; you can insert one peg and twist to work it in, pull it out and do the same with the other. Let me know in the comments if this is problematic and I'll resize them slightly.
The frame can be mounted either horizontally or vertically on two DIN clips. The friction fit is excellent with PLA, but the parts should probably be bonded for permanent use.
The pegs on the clips print fine without supports. Initial fit may be a bit tight; you can insert one peg and twist to work it in, pull it out and do the same with the other. Let me know in the comments if this is problematic and I'll resize them slightly.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
