Din rail mount

This is designed for my Ratrig VCore3

I have attached a dimensions file for the Din rail - you need to cut out the ends to fit with a hole in the middle or alternative drill a hole in the middle up to you - but no matter what the rail does not fit directly on a 400x400 RR VCore3

Im not 100% sure but i think you can just deduct 100mm or add 100 mm for the 300 or 500 model

The small holes where you can add a M3 nut is for future use, im planing on designing some custom modules for tightening wires etc. but not done yet.. WIP :-)

The mounts i found from VoronDesign Github page

https://github.com/VoronDesign/Voron-2/tree/Voron2.4/STLs/VORON2.4/Electronics_Compartment/DIN_Brackets