Thingiverse
Din Rail SSD Mount
por truglodite
3
Descargas
1
Likes
0
Makes
I designed this thing to mount a standard 2.5" SSD on a din35 rail. It has an offset to give additional room to the side where wires plug in. I added a "pry bump" to protect the corner of the SSD during removal.
It prints best with no supports, 0.45mm line thickness, and 2-walls (with a brim if you use ABS or nylon).
It prints best with no supports, 0.45mm line thickness, and 2-walls (with a brim if you use ABS or nylon).
truglodite también publica en
118 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
