DIN Rail Stand

I designed this stand to mount a 35 mm DIN rail at an angle on a desk or workbench. It makes it much easier to wire things up, test hardware, or show a setup during demos.It works with any DIN rail mounted components like power supplies, relays, terminal blocks, network switches, safety modules, etc. I mainly use it for PLC and automation hardware, but the stand itself is not limited to that.The angled design gives better visibility and access to the terminals compared to having a rail lying flat on the table. The base is wide enough to keep everything stable, even when multiple modules are mounted.PrintingPrinted in PETGNo supports requiredAround 20–30% infill works wellPrint flat on the basePETG is recommended if you plan to mount heavier DIN rail components.