DingBox

A box that dings!

A vastly overpowered build that uses a Pi Zero W to ring a little bell using a solenoid.

You will need to print these files:
- `hammer.scad`
- `case_base_complete.scad`
- `case_lid_complete.scad`

The other files are either imported or used to position things correctly (like the bell + solenoid).

Depending on the bell you use you may need to move the bell mount post. I've made it a slot rather than a hole which gives you a bit more wiggle room for small adjustments.

In addition to the print you will need:
- A Pi Zero W + 5v 2A power supply (micro USB)
- A bell to mount on top + the screw to mount it
- 4 x M2.4 screws, any length up to 20mm
- 5v solenoid [(I used this one)](https://www.mindkits.co.nz/store/p/8922-Solenoid-5v-small.aspx)
- A TIP122 NPN transistor, or simmilar (to turn the solenoid on/off)
- An axle for the hammer to turn on - I used a small nail with the head removed
- Resistors and wires

You will want to remove the