Thingiverse
Dino brush
von worthingsteve
19
Downloads
12
Likes
0
Makes
this version has holes to fit the brush heads. my original design had little keys that the heads went over but my son kept twisting them when pulling the brush out so I made a method that wont break when twisted.
May need some final dressing to fit the brushes into the holes.
heads are 12mm at the base and the holes are 12mm so a little polishing is all that is required.
May need some final dressing to fit the brushes into the holes.
heads are 12mm at the base and the holes are 12mm so a little polishing is all that is required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!