Thingiverse
Dino X-Ray
door TheMazePrinter
9
Downloads
13
Likes
0
Makes
An x-ray of a dinosaur.
Print at 100% infill with a layer height of 0.2mm with a base layer of 0.32mm
Use any colors you'd like, either via AMS or by manually swapping filaments as indicated below.
Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.8
PLA SPARKLE BambuLab Slate Gray Sparkle Transmission Distance: 3
PLA BambuLab Matte Ash Gray Transmission Distance: 10
PLA BambuLab Basic Jade White Transmission Distance: 3
Swap Instructions:
Start with Charcoal
At layer #3 (0.72mm) swap to Slate Gray Sparkle
At layer #5 (1.12mm) swap to Ash Gray
At layer #8 (1.72mm) swap to Jade White for the rest.
Happy printing!
Print at 100% infill with a layer height of 0.2mm with a base layer of 0.32mm
Use any colors you'd like, either via AMS or by manually swapping filaments as indicated below.
Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.8
PLA SPARKLE BambuLab Slate Gray Sparkle Transmission Distance: 3
PLA BambuLab Matte Ash Gray Transmission Distance: 10
PLA BambuLab Basic Jade White Transmission Distance: 3
Swap Instructions:
Start with Charcoal
At layer #3 (0.72mm) swap to Slate Gray Sparkle
At layer #5 (1.12mm) swap to Ash Gray
At layer #8 (1.72mm) swap to Jade White for the rest.
Happy printing!
TheMazePrinter publiceert ook op
20 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
