Thingiverse
Dioder Detolf Clip
by zpbruno
29
Downloads
20
Likes
0
Makes
Clips to support Dioder lights in the middle of Ikea Detolf Shelves.
Print 6 of them in the orientation shown in the build photo. No supports were needed on my Aurora A3 with PLA with an 0.25 mm layer height. Brims are recommended to avoid what happened to the one outlier in the photo. (New reel of filament, first print, old masking tape too.)
Inspired after the fact by https://www.thingiverse.com/thing:24580. I had already mounted the LED strips in the middle of the shelves with the supplied double-sided tape but they were starting to fall down, so I made these up.
Print 6 of them in the orientation shown in the build photo. No supports were needed on my Aurora A3 with PLA with an 0.25 mm layer height. Brims are recommended to avoid what happened to the one outlier in the photo. (New reel of filament, first print, old masking tape too.)
Inspired after the fact by https://www.thingiverse.com/thing:24580. I had already mounted the LED strips in the middle of the shelves with the supplied double-sided tape but they were starting to fall down, so I made these up.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!