Thingiverse
Dipole Centre V3
von gards50
2
Downloads
0
Likes
0
Makes
Great simple design, made a few tweaks from original design by Koppo by removing pole holes on back side and placed hole at top centre for clip.
Also, made larger holes for binding posts as mine were larger. Plus made strain relief holes open so wire can be routed through when hooking up & disconnecting wires from binding posts.
Made using Overture PETG.
Also, made larger holes for binding posts as mine were larger. Plus made strain relief holes open so wire can be routed through when hooking up & disconnecting wires from binding posts.
Made using Overture PETG.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!