Thingiverse
Direct Drive Bowden Extruder; MK8 version
von cfeniak
90
Downloads
52
Likes
0
Makes
Direct Drive Bowden Extruder for mk8 pulley
-simple, open, & compact
-easy to clean and adjust
-mounts with two M5 bolts at 20mm spacing
-designed to be drilled out for 1.75 or 3mm filament
-designed to be drilled out for a 5mm or 1/8 coupling
-designed for a mk8 pulley
-pulley is positioned close to motor base to reduce cantilevered load on motor shaft
-tensioning bolt catch is slotted to allow quick release functionality
-simple, open, & compact
-easy to clean and adjust
-mounts with two M5 bolts at 20mm spacing
-designed to be drilled out for 1.75 or 3mm filament
-designed to be drilled out for a 5mm or 1/8 coupling
-designed for a mk8 pulley
-pulley is positioned close to motor base to reduce cantilevered load on motor shaft
-tensioning bolt catch is slotted to allow quick release functionality
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
