Thingiverse
Direct drive cable arm
von Bjern
0
Downloads
0
Likes
0
Makes
A 120mm and 100mm cable arm for keeping gantry cables lifted from bed.
Created the arms for fitting with TwoPuncakes's cable chain mount on the old extruder plate for Ender 3 in combination with cable chain:
https://www.thingiverse.com/thing:4592642
https://www.printables.com/model/80695-ender-3-cable-chain-extruder-mount
https://www.thingiverse.com/thing:2920060
The arm mounts in the two right holes in the X direction for the axis. A tad longer screws are needed and some lock nuts for secure mounting.
Ziptie holes are running along the arms for convenient management.
Created the arms for fitting with TwoPuncakes's cable chain mount on the old extruder plate for Ender 3 in combination with cable chain:
https://www.thingiverse.com/thing:4592642
https://www.printables.com/model/80695-ender-3-cable-chain-extruder-mount
https://www.thingiverse.com/thing:2920060
The arm mounts in the two right holes in the X direction for the axis. A tad longer screws are needed and some lock nuts for secure mounting.
Ziptie holes are running along the arms for convenient management.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
