Thingiverse
Direct Drive Extruder Mounted Cable Support
door Badadz
3
Downloads
2
Likes
0
Makes
Direct Drive Extruder Mounted Cable Support
Designed this for my own need where I wanted the Cables from my Direct Drive on my Ender 3 Pro to be managed to the left.
Simply cable tie this to the extruder through long opening and then use short openings to mount the cabling.
- It is versatile as it can be mounted on top, below (This is what I did), or on the sides.
Two sizes:
Regular
Small (I used this one as I also put 1/4 loom on my cabling)
Print Directions: Do NOT use Support (It will bridge across the openings)
Other Parts you might need if cabling for Direct Drive on Ender 3 Pro or similar:
Ender 3 Front X-Gantry Cable Support - https://www.thingiverse.com/thing:4868520
Designed this for my own need where I wanted the Cables from my Direct Drive on my Ender 3 Pro to be managed to the left.
Simply cable tie this to the extruder through long opening and then use short openings to mount the cabling.
- It is versatile as it can be mounted on top, below (This is what I did), or on the sides.
Two sizes:
Regular
Small (I used this one as I also put 1/4 loom on my cabling)
Print Directions: Do NOT use Support (It will bridge across the openings)
Other Parts you might need if cabling for Direct Drive on Ender 3 Pro or similar:
Ender 3 Front X-Gantry Cable Support - https://www.thingiverse.com/thing:4868520
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
