Thingiverse
Dis Stik End Cap
von DisStik
0
Downloads
1
Likes
0
Makes
Dis Stik End Cap protects that shaft from being scuffed up on the bottom. If you set Dis Stik on the ground to extend it then this will surely help keep it lookin clean!
Printed from TPU
All 3D print designs have been created by Ben Leiber
Printed from TPU
All 3D print designs have been created by Ben Leiber
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!