Slicer Discord
Disappear_ball_magic – 3D-Druckmodell von Thingiverse Thingiverse

Disappear_ball_magic

von yorim
39 Downloads
24 Likes
0 Makes
Zum Modell
This is a magic trick from the 80's
it plays like this:
you open the cover to reveal the ball
the you take out the ball and put it in your pocket
then close the cover
say your preferred magic words like "abbrra ca dabra"
then open the cover again to show that the ball
was transferred from your pocket back to the little vase.
taddamm!!!

instructions for building
after printing all the parts
use some glue (i used epoxy) to connect the half ball
to the secret compartment.

good luck!

Enjoy !
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
großer Druck
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 2/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
200 mm (Groß)
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen