Slicer Discord
Dish scrubber holder – 3D-Druckmodell von Thingiverse Thingiverse

Dish scrubber holder

92 Downloads
77 Likes
1 Makes
Zum Modell
We used to keep our kitchen scrubber in a shallow dish next to the sink. My wife didn't like how it could sit in a little puddle of water if it hadn't been wrung out thoroughly, so she swapped out the dish for a binder clip. I absolutely despise the binder clip. It worked great for standing up the scrubber and letting water drain out of it, but it was a pain to put on and I was just opposed to the general idea of a binder clip as a sponge holder.

Printer to the rescue! This little dish sets the kitchen scrubber above the bottom of the dish so water can drop down into the tray, letting the scrubber dry and avoid growing nasty bacteria. If there's considerable drippage, the honeycomb patterned shelf lifts off and the tray can be poured out and/or cleaned.

This may serve well as a soap tray, too. Let your domestic imagination run wild and be sure to share by posting your make.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
ABS
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

mikeymakesit veröffentlicht auch auf

76 zusätzliche Modelle auf 3 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen