Dishwasher knob

After the control knob of my Beko dishwasher broke in my fingers, I made this non genuine replacement part for the DFN05X10S dishwasher.Fits and works well.After printing, before fittingTo get this to fit I intentionally made it to be a tight fit. It is actually that tight a fit that to make it go on, boil a kettle and run some boiling water onto the sleeve where it slides over the switch cam, turny bit.Make sure you don't burn/scald yourself as I did this pour over, wait a few seconds, tip the water out three times to soften the sleeve a little. After this it pushed on fairly easily and then cooled quickly to fit perfectly.I printed with supports as it was my default profile, but don't think they are necessary as they are only in the finger grips cut-outs which are quite small.Printed with three walls to add strength to the sleeve making it less likely to break with the rotation applied in normal use.