Slicer Discord
DIY Ant Trap – Modelo 3D imprimible de MakerWorld MakerWorld
Other House Models

DIY Ant Trap

317 Descargas
48 Likes
249 Makes
Ver Modelo
SummaryTo successfully kills ants using this device, you can use commercially available liquid ant poison or, make two batches of bait using boric acid which is cheap to purchase from the drug store. Type 1: mix 1/4 tsp of boric acid with1 tbs peanut butterType 2: mix 1/4 tsp of boric acid with 1 tbs jam/honey etc. Place a small portion of both baits in the trap, fasten the top and place the trap on the floor near the area you observe the ants entering the house. If you don't see where the ants are entering, place it near an outside door. The more the traps you have, the quicker the results. Check regularly to ensure you have bait in the trap. Leave it place for at least a week while the ants take the bait back to their nest. You should notice a difference within 2 to 3 days as the boric acid kills the ants in their nest. Boric Acid, (Not BORAX) which is a key ingredient in many store-purchased ant-bait products, can be inexpensively purchased as a powder at any reputable drug stor
Categoría
Other House Models
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección