Thingiverse
DIY Ebike
by lee_kyle_
18
Downloads
13
Likes
0
Makes
I use gyroid infill for each part. Make sure the 16T pulley is printed with lots of walls for strength.
The 104T pulley can be printed with 2 walls and decently high infill.
The battery case is designed for a 12s6p made of 21700 5000mAh batteries.
The vesc is a Flipsky vesc6 with a heat sink from Banggood.
The motor is 8318 Brushless motor from Aliexpress.
The tensioner has 3 6x19x6 ball bearings supported by the shaft.
The 16T Pulley has a metal guard cut from an old baking tray. There's an M5 bolt going through it.
All the bolts are M2, M3, M4 and M5.
The 104T pulley can be printed with 2 walls and decently high infill.
The battery case is designed for a 12s6p made of 21700 5000mAh batteries.
The vesc is a Flipsky vesc6 with a heat sink from Banggood.
The motor is 8318 Brushless motor from Aliexpress.
The tensioner has 3 6x19x6 ball bearings supported by the shaft.
The 16T Pulley has a metal guard cut from an old baking tray. There's an M5 bolt going through it.
All the bolts are M2, M3, M4 and M5.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
