Slicer Discord
DIY Garage Door Case – 3D-printbaar model van Thingiverse Thingiverse

DIY Garage Door Case

door derektata
2 Downloads
0 Likes
0 Makes
Model downloaden
Modeled in Fusion360

So a couple years ago I bought a dev board to open my garage door remotely from my phone, and had it sheltered in an empty wallbox, which worked, but made the terminals/buttons inaccessible to the outside. So I made this to solve that problem.

Both sets of screw down terminals are accessible from the outside now, as well as the buttons and micro USB port.

I used hot glue to secure the board to the bottom part of the case, and to reduce trouble with assembly, I used duct tape to hold the buttons in place while snapping the top and bottom halves together.

NOTE: The buttons will fit be VERY snug at first, use a round file and flat file to sneak up on the correct fit.
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
uitgebreide nabewerking
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 2/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Lijmen, Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

4 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie