Slicer Discord
DIY In-Wall Sonoff Light Switch – Modèle 3D imprimable de Thingiverse Thingiverse
DIY In-Wall Sonoff Light Switch – Bild 1 DIY In-Wall Sonoff Light Switch – Bild 2 DIY In-Wall Sonoff Light Switch – Bild 3 DIY In-Wall Sonoff Light Switch – Bild 4 DIY In-Wall Sonoff Light Switch – Bild 5 DIY In-Wall Sonoff Light Switch – Bild 6
Electronics

DIY In-Wall Sonoff Light Switch

84 Téléchargements
70 Likes
0 Makes
Voir le modèle
This is an old version. Please see version 2 of the in-wall sonoff light switch. Version 2 doesn't require the additional pcb and button. You can find it here: https://www.thingiverse.com/thing:2632463

After printing, you will need to insert the Actuator through the back of the Mount Plate and **carefully** force the tabs of the Actuator into the holes on the Mount Plate. Once you have the Actuator installed, it will be a little stiff and hard to move, but just work it back a forth a few times and it will soon operate smoothly.

You will also need to make up the PCB that holds the pull-up resistors and buttons which the actuator presses. I just used some perf-board and salvaged buttons and resistors to make it. The PCB should be shaped as in the image above because the sonoff's button and LED are rather tall and I wanted to make sure that the whole switch enclosure would fit inside the wall with the existing wires tucked behind it.

Below is my video describing my Sonoff In-W
Catégorie
Electronics
Source
Thingiverse
Publié
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA, ABS, Polycarbonate
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection