Thingiverse
DIY ledwall for PixelArt
por Rof3D
9
Descargas
6
Likes
0
Makes
This is a ledwall made with mpcnc and 3d printer!
It is made by cutting with mpcnc the led matrix in a grey foam pannel this process is hard because the foam powder stuck inside the roller of mpcnc and you need to constantly vaccum all the maachine!!
Then print the reiforced angle with a 3d printer.
The ledwall use ws2811 led chain and wifi led smart controller and power supply 5v 6 amps.
The led chain are simply put into hole and glueed with a little of hot glue and then you need to solder the two 50pcs chain togheter and connect elettronic and power supply!
To use the ledwall with the smart controller you need to dowload the right app and connect to the wifi of the controller set the matrix and play :)
Enjoy and share!!
It is made by cutting with mpcnc the led matrix in a grey foam pannel this process is hard because the foam powder stuck inside the roller of mpcnc and you need to constantly vaccum all the maachine!!
Then print the reiforced angle with a 3d printer.
The ledwall use ws2811 led chain and wifi led smart controller and power supply 5v 6 amps.
The led chain are simply put into hole and glueed with a little of hot glue and then you need to solder the two 50pcs chain togheter and connect elettronic and power supply!
To use the ledwall with the smart controller you need to dowload the right app and connect to the wifi of the controller set the matrix and play :)
Enjoy and share!!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!