Thingiverse
DIY Lego compatible Motor
by Daverolos
50
Downloads
35
Likes
0
Makes
This is a Housing for a small Motor (32,2x15x20,4mm without axle).
I used a ordinary BEC-Plug to connect the Motor with an Lego extension wire.
After Printing you have to cut a treat in the four little holes on the back of the Housing and assemble the housing with four M3 Screws.
I used a ordinary BEC-Plug to connect the Motor with an Lego extension wire.
After Printing you have to cut a treat in the four little holes on the back of the Housing and assemble the housing with four M3 Screws.
Daverolos also publishes on
3 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!