Thingiverse
DIY Opentrack clip
von MrCrabz
3
Downloads
0
Likes
0
Makes
Made this to house 3 IR Led's in the default opentrack dimentions.
Inside the clip there is space to run wireing. Powering the LED's of a regular USB cable using 5V and a resistor.
For the mounting on the headset i've used a aluminium strip 20x3mm cut to length with a hole in it. and for attaching to the headset used a paper holding clip.
3d model is far from perfect but works so feel free to use.
Inside the clip there is space to run wireing. Powering the LED's of a regular USB cable using 5V and a resistor.
For the mounting on the headset i've used a aluminium strip 20x3mm cut to length with a hole in it. and for attaching to the headset used a paper holding clip.
3d model is far from perfect but works so feel free to use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!