DIY Racing Sim Sequential Shifter

## DIY Racing Sim Sequential Shifter ##

Thanks for your interest in my DIY 3D printable Racing Sim sequential shifter.
The idea was to design it to be strong & long lasting, but also cost effective and without any special components required.
In total, print time will be about 1.5 days, and require around 500 grams of filament. I chose PLA and have had no issues with long term use.
I've been using mine for ~6mths of occasional use and it's been absolutely flawless. I have made some small changes/improvements to the model that is available here since using this first prototype.

- - -

## / / Components Required \ \ ##

#### 3D Printed Components ####

**1x** Main Shifter Body
**1x** Shifter Shaft
**1x** Bottom Cover
**4x** Switch Spacers (I made these a separate component rather than merging into the main body mostly just for ease of printing.)
**1x** Shift Knob (Optional - I'd recommend you to use any real car shift knob with an M10 x 1.5 thread)
**1x** Pivot Pin &