Thingiverse
DIY sous vide heating element holder
door brentarogers
11
Downloads
11
Likes
1
Makes
Made to hold 3 * 300W (Norpro 559) heating elements. The container bracket is made to fit my particular cooler, but could be adapted to others as needed.
Mounting holes are 3mm, spacing is 40mm * 140mm.
The plug end needs to be cut off in order to fit through the hole, and a slight bit of trimming on the top of the white plastic section of the heater, at least on mine.
Mounting holes are 3mm, spacing is 40mm * 140mm.
The plug end needs to be cut off in order to fit through the hole, and a slight bit of trimming on the top of the white plastic section of the heater, at least on mine.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!