Thingiverse
DIY switchable magnet
di greenail
107
Download
70
Likes
0
Makes
https://www.youtube.com/watch?v=YUt_nx_uZZ0
Switchable Magnet.
Center: 17.5mm turned down from .75" all thread
Outer bars: 3/8 (9.5mm)
Magnets: N42 10x5
This is a tad different than the design created by Andrew Klein. It is smaller, the outer "bars" go all the way through, and only the top magnets rotate.
Printed on cetus3d in PLA with 20% infil and .2mm layers
Switchable Magnet.
Center: 17.5mm turned down from .75" all thread
Outer bars: 3/8 (9.5mm)
Magnets: N42 10x5
This is a tad different than the design created by Andrew Klein. It is smaller, the outer "bars" go all the way through, and only the top magnets rotate.
Printed on cetus3d in PLA with 20% infil and .2mm layers
greenail pubblica anche su
1 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
