Thingiverse
DIY Videolaryngoscope
von Homexperts
9
Downloads
10
Likes
0
Makes
This vidolaryngoscope was inspired from www.airangelblade.org .
Some modifications were made to make printing and cleaning easier.
Disclaimer:
A DIY-Videolaryngoscope is not a medical product! It has not been tested according to any specifications (BfArM/MPG, FDA, ANVISA, etc.) and must therefore not be used on humans. The application is limited to training and education (as well as perhaps a life-saving application in underdeveloped regions or crisis areas). Use on the patient could result in injury and life-threatening complications.
3D Printing
Layer height: 0,2 mm, nozzle: 0,4 mm, infill: 100%
PA (nylon) is recommended as the material as the printed part becomes dishwasher-safe and high-strength. But even PLA delivers excellent results, except for the temperature sensitivity.
Some modifications were made to make printing and cleaning easier.
Disclaimer:
A DIY-Videolaryngoscope is not a medical product! It has not been tested according to any specifications (BfArM/MPG, FDA, ANVISA, etc.) and must therefore not be used on humans. The application is limited to training and education (as well as perhaps a life-saving application in underdeveloped regions or crisis areas). Use on the patient could result in injury and life-threatening complications.
3D Printing
Layer height: 0,2 mm, nozzle: 0,4 mm, infill: 100%
PA (nylon) is recommended as the material as the printed part becomes dishwasher-safe and high-strength. But even PLA delivers excellent results, except for the temperature sensitivity.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!