Thingiverse
DIY Wireless Charger
by zorogue
43
Downloads
36
Likes
2
Makes
Needed a small case for some DIY wireless chargers I purchased. The model prints fine without supports and snap fits together (Thanks to the Adafruit tutorials).
I printed mine in Matterhackers build series PETG. The board does get hot but PLA should still do fine. I picked PETG so i could put one in my vehicle and it withstand the hot Florida summers.
Wireless charger can be found here.
Edit:
Looks like the original charger is no longer available.This one looks to be identical but someone else will have to confirm.
Added a new charger top with rounded edges and a charging stand that fits the new top. I'm currently using it with an iPhone 8 inside an otter-box case and seems to be working well but i may still end up having to adjust the alignment of the charger on the back of the phone.
I printed mine in Matterhackers build series PETG. The board does get hot but PLA should still do fine. I picked PETG so i could put one in my vehicle and it withstand the hot Florida summers.
Wireless charger can be found here.
Edit:
Looks like the original charger is no longer available.This one looks to be identical but someone else will have to confirm.
Added a new charger top with rounded edges and a charging stand that fits the new top. I'm currently using it with an iPhone 8 inside an otter-box case and seems to be working well but i may still end up having to adjust the alignment of the charger on the back of the phone.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!